Most reacted posts

Wouldn't they simply be the last to fully charge?

Would like to be able to monitor my system from a far

Does a switch exist that would switch to a fresh battery bank automatically?

I have 2 rows of 4 batteries in parallel and those batteries are in series to make 24 volts.I believe the cable size is "0". Much bigger than the "4" that was recommended

Thank You

no they are not. 2 sets of 4 batteries in parallel. .Those hooked up in series to make 24v.

Across the room is not" A Far"

This basically my seTuP. I I have added 2 more batteries. The wires from the charge CONTROLLER FEED IN ON THE BOTTOM RICHT AND THE TOP Right. THE BATTERIES ON TOP ALL RUN 14.3V. tHE ONES ON THE BOTTOM RUN AT 13.3 VOLTS. A LL BATTERIES ARE 3 MONTHS OLD AND ARE THE SAME IN EVERY ASPECT.

There seems to be a few ways to wire this bank. Any idea on "The Best Way"? I understand DC travels on each strand of wire So what about bus bars? Wouldn't cable be better?

I love the truth. Not what someone has read or simply believes is true. Red bud seems to speak from personal experience and is doing it now I am not the kind of guy who seeks confirmation of what I already believe, there is no personal growth in that. So this is what I have decided to do. I...

I heard back from my charge controller Manuf. SRNE today. They SAID IT WAS NORMAL. So my first mistake was buying a SRNE product.

So Randy what do you think about substrate's reply

The picture is about 2 weeks old, I now have 8 batteries and in a few weeks I will have 10 batteries. I'm thinking 5 groups of two with charging wires on each group. I will charge the batteries tomorrow and let them rest for the 4 hours

What is so unusual about it?

So do you leave the shunt in the permanently? It is a resistor, right? Wouldn't' it decease efficiency?

I have a 24v battery bank made up of 8 100ah Gell batteries. There are 2 banks of 4 batteries. The problem is that there is almost a full volt between the battery banks. 13.3v and 14.2v. I am using the SRNE ML2440 charge controller. and 1000w of PV. Any suggestions would be appreciated. Ralph

I have a Snat inverter and A SNRE charge controller

I have 4 gell100ah batteries in a 24v arrangement. I am getting ready to but 4 more, but I'm wondering If I could buy 150ah batteries and add them to my Battery bank with out to much problem? Thank you in advance

have a 24v battery bank made up of 8 100ah12v Gell batteries