Recent content by sampler

http://support.epsolarpv.com/support/solutions/articles/48000974377-how-to-connect-the-remote-battery-voltage-sensor-rbvs-to-the-battery-

Hey! I have built a 48 volt lifepo4 battery bank with 16 120 amp 3.2 cells and it works well. I use a simple bms daly 48v 16 s 60 amp (see picture) for my epever I run the pc software and a computer where I can make all settings and see charging in real time .. incoming power comes from solar...

Hey! Should collect information on my setup so you can take part of it..But I can say already now that it works well..I will come back with more info soon

Hey! Anyone know why this setting means? Overvoltage disconnect? in epever tracer ... The basic setting for 48 volt lifepo4 is set to 62.40 volts divided by 16 = 3.9 volts per cell Is not it a maximum of 3.56 per cell?

Is there anything I can do to ensure fire? Is it a good idea to put the battery in an aluminum box to possibly eliminate fire?

Hi thanks for the information very well explained I think I use the settings in the picture I attached. To begin with then fine tune gradually Thanks again Uffe

Hey! Was in contact with epever and asked how I set up my solar regulator and I got the answer to contact LiitoKala for a specific setting of these batteries But get no answer from them so that was why I asked here..Maybe someone who has bought these batteries and know how to set the parameters...

Hey! does anyone have a suitable charge profile for these batteries LiitoKala lifepo4 100ah? Have ordered these batteries but have not received a response regarding the charging profile Regards Uffe

Hey! How have your batteries fared? Have you got a charging profile for these batteries? Have ordered these batteries but have not received a response regarding the charging profile Regards Uffe

Hey! Got this information from epever. Anyone have any objections to this? Hey! Got this information from epever. Anyone have any objections to this?

Can anyone look at this setting 48v lifepo4 16s with BMS eperver tracer. Something that needs to change? Thanks in advance Uffe / Sampler

Absorption? Does not have that parameter in my epever tracer settings?

Hey! Can you fix a new image on your settings. The image you have now is very difficult to see Do you have an image with better resolution so I can see your settings Thanks in advance

Hi Thanks for the answer..Good that I asked :) as slowly I am not a professional at this. Please would you fill in the correct values in the attached picture? Thanks in advance Uffe

Hey! Have a question I have built a 48v 16s battery with BMS and have an epever tracer 50 amp solar regulator and the question is do I really need to change anything? See no difference in the settings for type sealed lead acid batteries and LiFePO4? It's bms that takes care of charging the...