Recent content by Samuel

Thanks! That's interesting. Which Port on the BMS do you use with your Code? The UART, where in my case the Bluetooth-Dongle is connected to? Or the Monitor-Port, which I can use with the Sinowealth Software. I would prefer to use the monitor port. Do you compile your c++ code for an Arduino...

I'm trying to read out all values from my Daly Smart BMS 4S 100A 12V and integrate this values in my smart home system (openhab) At the moment I can connect to BMS with the Android-App over Bluetooth and also with a windows 10 pc and the sinoweath software which is connect to the monitor port...

Thanks for all your help. I changed the connection from alligator clips to XT60 and ring calbe lugs. And now I'm charging with the nearly 6A.

OK, thanks for all the answers and you are all right. I didn't realized that the curve is sooo flat in this charging-state. Thank you very much. The wire cross section should be big enough. But could the croco clamps be a problem? What do you think?

Hello, I'm topbalancing my 4 x LiFePo4 280Ah Varicore Cells at the moment. I'm doing this with small SkyRC Charger. I configured it with the following parameters. Voltage 3,65V Max Charge Current 6A ChargeMode LiFe Cell Count 1S (Because all Cells are Parallel) OK, I know that will take a long...

OK, thanks! I will observe the charging process. What parameters should I look at? Only that the Voltage must not be over 3.65?

OK, thanks for your answer. I'll try it with this charger. Otherwise i will buy a stupid powersupply which will deliver 3.6V

Is nobody here who can say something about this charger? Is it possible to top balance with it?

Hello! I hope my ordered 280ah cells will arrive in a few days. I have no power supply like you use, but I have a charger which also habe a LiFe-Mode. Do you think it is possible to top balance with this charger https://www.skyrc.com/iMAX_B6mini_Charger I can set it to LiFe-Mode and choose...