Yes, I get the cell data in IO-BROKER via Growatt Plugin from PLCHome. So at the end it comes from Growatt shine cloud.
So a lot of possibilities there its get lost.
I have no CAN Trace, but asked SEPLOS support.
I got an answer from SEPLOS support, They checked on there side with these...
I have only one issue. Cell3 is not delivered right or it has always the same wrong value.
I can not trace CAN bus - so I do not know where it is get lost. On SEPLOS or Growatt side.
With RS485 it is fine.
But I do not investigate to much - I know this cell follows the same curve as the...
Yeah I will try. Sounds like a plan. Thank You.
I am not sure if I am allowed to post firmware.
CAN1101[FW27-DFSET_GW02_NEW_210616].ehex The version I got from seplos support worked for me - with Growatt SPH 4600
CAN1101[FW27-DFSET_PN01_210520].ehex. This version did not work at my side...
Thx. Yes I have an active balancer - this Haltec one - but was to lazy to crimp and connect yet. I know I should do.
My second battery order was not as good as the first ones. I have 2 cells that are bad. Cell 9 always goes down first on discharge quite early.
I already have seen it on the...
I have Seplos 16s 150 BMS with 280 Lifepo4 connected to my Growatt 4600 SPH. Works great now:
I connected CAN to CAN with original Pylontech cable.
I have got an firmware update for BMS from Seplos support and selected Growat CAN protocol.
It now shows even cell voltages, all temperature...