Most reacted posts

when i disconnect solar and soc is well below parameter 12 i do get charging and it goes into bypass mode. i can charge a bunch but it stops randomly before parameter 13. i will try USE for the inverter that is set to EG4 Why do i even need to communicate? Won't the batteries take care of...

one one inverter parameter 5 is set to EG4 and USE on the other. I have tried everything for 12 and 13 making sure that they are both higher than the current SOC. Charging from grid almost always stops well before the setting of 13 i left 26 and 27 at default because I did not think they...

trying to post again i would also like to see the word doc

for some reason the forum hides most recent replies until you click show more.

they are obviously incapable of editing a PDF or at least fine it such a chore that they would rather field support request unnecessarily. when they "updated" the manual in the area of error codes they could not manage to add what was left out to the old chart instead added some crap after it...

i wrote a reply but it was lost. just saying that there are still some good manuals. i bought a wazer (wazer.com) and the manual is very good. if i set param 5 to USE for both inverters what should i set 26 27 and 29 to for charging my EG4 batteries, the ones with the panel?

now the reply showed up must have been delayed or my browser did not refresh properly?

how about the word doc i think many would like to see it

I have two EG4 5600EX inverters connected in split phase mode. I can not get solar and grid (connected to grid or generator) to charge at the same time. Parameter 16 is set for SNU which is supposed to allow this. But if I connect the solar input with even a minimal charge the grid is...