Recent content by steepee

@400bird @BentleyJ Thank you, guys. Which software do you use to open XF0 files (.xf0)? I tried using Notepad, and the result is as follows: XW-Pro will display F49, even if it's just a warning. There isn't an option to display W49. The main distinction between F and W is that in the case...

Thank you both @400bird @BentleyJ for the prompt reply. I really appreciate it. The solution for F72 was downgrading firmware. It is so weird, but I don't see the F72 fault on version 1.11 anymore as it was on version 2.04. Where can I find these release notes? I tried to find them on the...

Looks like HAB-XL and XW-PRO are not compatible. I am trying to commission the system for the second month; all I get is new errors each day. Wiring has been checked twice, and it matches a Schneider Split Phase configuration. Settings were set as they were in the manuals. I downgraded...

Correct. Got you. What do you have, Backup Control Switch? It is in the closed position while the grid is operating, and it opens when the grid is down. However, when the grid turns on, it becomes an F72 fault, which will never disappear until you physically restart XW-PRO by pressing the...

@400bird "If your SSR/contactor set up takes a while to open/close you can adjust that with the timers under external contactor." I don't see any timers under this contactor...

Hi @400bird , Thank you for the prompt reply. No, there is no fourth inverter. HAB-XL Batteries are marked from #1 to #4. Yes, each battery is 20 kWh. What do you mean by "search mode"? Are you trying to figure out what else can consume power? This system is just for backup. The Master...

Good morning everybody, I have a system that consists of 4 Schneider XW-PRO 6848 inverters, 4 KiloVault HAB-XL batteries, and a Solid State Relay with an External Contactor (see attached single-line diagram). I am experiencing some issues with it: 1. The system doesn't have a UPS, so when I...

Thank you for the information. I've adjusted the HBCO and reset the fault. I appreciate your help!

My friend has a warehouse, so he had this battery monitor with balancer and was able to help me with this and installed it quickly. Would you mind to look at this problem with F49 on Schneider Inverter: https://diysolarforum.com/threads/f49-fault-on-schneider-xw6848.70750/post-906228 ?

I think we have resolved this problem together. What I have done is put the correct numbers in the local InsightHome portal, as you previously mentioned. I also installed the Schneider Battery Monitor and the balancer, charged all the batteries, and pressed two buttons, < >, to calibrate the...

Hi everyone, I have an issue with the Schneider XW Pro. I got F49 error. How can I clear the fault? Is there any manual how to do it remotely via insightcloud?

I agree with you. Got you. So, what you think is the best solution to keep them balanced? Install the charge controllers? I don't think they have communication with the inverter, but I see some information on the portal. I'm not sure if it's calculated voltage and percentage from the...

Thank you so much for the valuable information you provided. I am using the cloud version, but I can switch to the local version on Friday. I think that the only difference is the interface between the cloud and local versions, or are there some technical aspects? I fully charged the...

Thank you for the prompt reply! I am charging with XW without a charge controller. Please see the attached screenshots.

Good day, I have a problem with the battery system. The system consists of a Schneider Inverter XW Pro 6848 and KiloVault HLX+3600 batteries (48V). The battery's state of charge seems to range from 85% to only 90% or maybe 91%. It appears that I need it to reach 99%. It also seems that if...