I spoke to Solis today who picked up the problem with the home usage not showing and mentioned the CT clamp as he said if all the produced is going to grid and nothing to house the battery will not discharge it will fully charge and not get used. So I played around with the CT clamp and now the...
I finally got hold of them installers and they also confirmed it’s in the wrong place the cable from the meter to ct is too short to put it in proper place cut it I guess so they need to send a new one and an engineer to fit it in the proper place.
This may have been spoken about before. Here`s the thing. I had a PV battery storage system installed in August last year but did not get much generation due to teething issues. Ok I am thinking that due to the unpredictable weather especially in Scotland. If I take my usage for 2024 usage cost...
Hi again newbie power generated is the same as used and nothing to grid so basically I am using all my produced my question is. Now the battery is fully charged the battery is now discharging until it uses its storage then it will start charging again now I am pulling from the grid is that how...
I spoke to Solis today they updated the firmware and he picked up the ct clamp issue so looking better now. I have raised my concerns as you say it’s a bit rubbish
Still having issues battery would not charge the CT clamp is on negative ac feed to the inverter small consumer unit pointing towards the feeds to the inverter. It was on the positive side pointing away towards the meter but no flow was showing and battery would not discharge. I am still waiting...
The battery is a puredrive II which is selected and Solis updated the firmware and were looking at the DC strings I mentioned only one string of 8 panels were plugged in to DC 2 and DC 1 is not populated. Not sure if it should have been wired in 2 x 4 panel strings.
This is the issue I am having the inverter RS485 puts out 1.45 volts dc and if you check the unplugged RS485 cable two pins it is 3.45 volts dc it then goes to the eastRon meter near the consumer unit pins 9 and 10 on eastRon meter should have 3.45 volts dc that means the meter is working and...
Hi All
I hope you can help. I have just had a system installed and it is generating and battery is charging however the house side of the inverter is not ouputing anything help appreciated
Hi Good day question which I am sure someone will answer. The Solis inverter flow graphic has circles with information inside the circle and information outside circle what does this mean is outside actual and inside total sorry don’t quite understand.
The app updated in the last couple of days for me and now the app sits with the wrong data until I force a screen change this never happened previously