diy solar

diy solar

Most reacted threads

  • Re-balance using BMS with low current?

    My DIY batteries are out of balance (I have top balanced using the guide in this forum before I put them in use), one cell hit 3.65v (overvoltage cutoff) while other cells are around 3.36v. during charging I did see [BLANCING] on the cell with higher voltage, but I think the bms passive...
  • Can 280/300ah cells reliably drive 2000w pure sine inverter

    Hi all, I am wondering if these 280/300/310ah cells can reliably power a 2000w inverter continuously (> 10 minutes) in a 12v setup? Let's assume BMS can handle this. I plan to build a 4s 12v system in an RV with a Renogy 2000w pure sine wave inverter, and run some high wattage...
  • 17v Vmax NewPowa vs 18v Vmax Renogy with Victron MPPT

    Hi, I am working a RV solar application with very limited roof space, the standard 100W panels won't fit. My goal is to have at least 200w panel on the roof so my panel options are as following. (due to AC unit shading, panels will have to be connected in parallel). (Vmax/Voc) 1. Renogy...
  • 2000w inverter with long wire, will it work (safely)?

    I plan to tackle the under powered inverter (1000w) problem, but due to the constraint of available space (I have a 16-foot trailer, space is very limited), the inverter has to be mounted far from the batteries. about 10 feet of cable run. I have read many posts on similar topics. In most...
  • Does Battleborn design their BMSes?

    I came across this post https://diysolarforum.com/threads/wow-inside-my-battleborn.27513/ and the picture shows a BMS inside the battery, it's really not that much different from JBD BMSes, same layout . The supplier model number seems to indicate it's a off-shelf unit. I have always thought...
  • JBD smart BMS displays wrong cell voltage

    Hello, A while ago I watched Will's youtube video on JBD Smart BMS and it looked nice so I purchase 2 of them (12v 4s 120A) from aliexpress https://www.aliexpress.com/item/4000425316662.html?spm=a2g0s.9042311.0.0.27424c4dTRne5e for 2 LiFePo4 banks. After the prep work (crimping...
  • 4awg lug terminal too big for 4awg wire ?

    I just purchased 10 feet WindNation 4awg red/black wires and 10pcs WindNation copper lug terminals from amazon, But it loosk like the copper wire core diameter is significantly smaller than the lug tube inner diameter. seems like I can push the entire wire with insulating jacket into the tube...
  • Temp sensor placement

    The 304ah cells and BMS both arrived so I will start to assemble my 2nd LiFePo4 battery soon. One question - where should I place the temp sensor? After watching Will's battery review videos seems making them in direct contact with the cells is not recommended? One year ago I built a 105ah...
Back
Top