OK, so I thought I’d report back just in case it is if any use to someone planning something similar in the future. I finally got around to completing [most] of my project over the Christmas holidays it was fun and it’s been running well for a couple of weeks now.
It took me a long time to put...
Hi all & following this thread with interest.
Like many of you, I have a situation where I can’t install a hybrid inverter near the incoming mains supply (it will be about 20 meters away). The route I want to take is with the Victron MultiPlus-II GX but as far as I can understand from their...
Thanks Steve, Yes I had actually spotted that and should have mendioned in my original post. I understand that energy meter is a hard-wired-in device (not a CT clamp), which adds a further level of complexity I'd rather avoid. Victron are pretty good with the documentation they publish but it...
Recognise this is an old thread, but it's very relevant to me.
I'm also considering a SPH6000 with a [home brew] 20kWh battery using Seplos BMS but was put off by the published 12kWh limit, which doesn't really make sense to me. I'm less concerned about the ability to recharge the batteries but...
Thank you, Steve. This is very useful and almost exactly what I plan to do.
The difference in my case is that I plan to use my wired LAN at both ends and also the PoE (also available at both ends) version of the Waveshares. I'll report back in a few weeks once complete.