TechRider's latest activity

Thanks! I really wanted to be done by 5/15 and I was able to do it! Yep, I used the JK Inverter BMS that has COM built in. It seems...

I also wanted to check that my batteries were performing well thermally. Things looked good. The heat on the actual batteries was a...

It's basically done! I still have to wait for my interconnect but I'm able to generate power and run off my batteries. Used a...

Hello. I ended up wiring a relay powered from the Sol-Ark 15/16 pins to the Tigo AUX port. I figured this will give me the best config...

That's how I have mine wired with this relay. Just out of principle I'd rather use the shutdown signaling circuit rather than just...

My RSD switch is wired to the pins on the Sol-Ark 15K. The Tigo is powered from a breaker in my main panel. When the RSD switch is...

My installer arrived with a N/C RSD switch. So, I supplied a SSR and did this. Yes, I know it doesn't do emergency shut down of the...

With the 15k, if you press the Emergency Stop button, you lose all power to the load panel?

Hello, I've been searching for the "best" way to enable RSD with the Tigo Optimizers and EPO with the Sol-Ark 15k. From what I've...

It's actually a limit of 360° of total bends, between pulling points. And no single continuous bends of more than 90°. But most people...

I'm going to concede this one to interpretation. (As many things in the NEC are) The code has always been "not more than the equivalent...

This is why I said that I would concede this one to interpretation. I have always interpreted (as I was taught) to be the equivalent...

Everything I found was no more than 3 90's in a pull. I have a little less than 3. The final bend to get on the roof is about 67°. I...

I just went through the same thing and just wrapped around the roof. If I ever change my mind, it's easy to remove.

Very nice! Have any pics of your sled in action?