OK that sounds terrible. I will put on my thinking cap and go back to the drawing board, and ponder a long while on your points there. I had the lingo backwards on the switch, good that you caught that. Thanks SeaGal
Hey SeaGal!
It is my fault for not clarifying that:
This van IS (will be) my house, so any lighting-for-security set up is being planned here for use while I am sleeping inside the van.
My thoughts about adding more lights to the already included backup camera led lights, are only there to take...
I have a major blockage in my solution finding here. I am 95% sure that everything else checks out here in my circuit, but I have reached todays limit on thinking through the circuit for a solution to my primary problem, as I am a major electrics beginner. My primary problem is as follows: I...
I wanted to ask this question before I plonked down another electrical wiring question that is unrelated to the specific topic of solar/batteries/tools etc - into the DIY Solar Power Forum. I am unsure if the general topic forum or beginners corner is a reasonable place to ask my questions. I...
Thank you, I shall heed this 230v vs 12v switch advice.
As to the automatic transferring of excess energy to different destinations, there is a built in relay on this victron battery management device that I am learning about right now, I am figuring out a way to set it up right now. I am...
I am reading related posts on this concept as I post this, as I clarify my understanding, I will remove this beginner post. I am mostly wondering about using the hot water reservoir as an accumulator of sorts, or if I should move the cold line accumulator back in the chain to after the pump and...
Update:
I like the look of those. Would you use 36 of them all the way down the non-hinged sides of your tilting panels? Neutron bomb proof! Nice!
I might just be a tad slow, but could you help me understand why maybe 3 or 4 wouldn't work? Connected opposite the side of the hinges? I am...
hey! I would love to see your idea via photos if you end up creating it. This process of idea osmosis-ing from the internet and applying our own ideas to this mix is so invigorating and exciting. I am just now entering the word of relays and I feel like Aladdin on my magic carpet, a whole new...
THANKS PEOPLE! I am realising now that I calculated the amperage wrong. I kept mistaking the 15w per pad for 15a per pad. oops. SO. each pad is only 1.25 amps in fact, and that means I do not need a 60a midi fuse there, instead I only need a 5amp fuse if I use all 4 pads. I can skip the relay to...
Hello! If anyone has any time to help me confirm the validity of my very simple battery heating pads circuit, I would be VERY grateful.
Here is the diagram I drew. I will have this W1209 thermostat switch (also attached in photos) activate when the temperature has dropped towards 0c freezing...
Superb, thank you MisterSandals. I will check these points as you have recommended, and return here with results once I have reached that stage, in the case that it could help someone else in the future. I like your thinking about direct to battery simplified connections. I need to think about...