How do you **actually** set parameters in the Smart BMS app and do your modifications instantly apply and show in the pertaining setup pages ?
I am asking you that because on my side only certain mods immediately apply (as the battery capacity) whereas some (as the sleep timer) never apply !
For...
I am using an 'old' 4S smart-BMS (no 2-pin reset connector), only UART and Monitor plus attached NTC (solid, no connector)
The only way I could wake it up was to connect it to a 'non'-intelligent 14.6V bench P/S and it now works fine.
However, as I wanted to reset the sleep timer to 65535 to...
I do, but even after I entered 1,2,3,4,5,6 some settings don't stick, e.g. 'type of battery' that never shows clearly as in your snapshots even if I can select it in a list (LFP/LI-Ion/LTO)
Could you please try 65535 (infinite setting that is 'no sleep') in 'sleep waiting time' and tell me if it...
@tsenator
I will try to get a hold of the version you are using (211209) so as to make sure we can cross-check results on each side ...
I finally (partially) solved the sleep timer issue by entering 15300 (that now sticks in the settings !).
Why 15300 rather than 65535, please don't ask !
I...
@tsenator : were you then able to set the sleep parameter to 65535 (infinite) ?
I used the same method as you did to wake it up (connecting it temporarily to a 14.6V PSU) but then I could not modify the sleep parameter in the Daly app ( see...