Search results

I have now ordered 2x 12V 15W silicone heating pads. Is probably the simplest solution

What is the calculation path?

resistors 10 Ohm

but I would like to have it on an area of 40cm x 40cm distributed from below on alu

But that would mean 6 x 25w =150W heating power, which is too high. Probably the load resistors would not withstand this in continuous operation. How can I simply limit the current? I need maybe 20-30Watt heating power

Hi, Does this also work if I connect the resistor directly to the 12V battery ?

everything has to be done via the SBMS0. the technology must be simple and not another 2-4 BMS. if the inverter ever burns out. Then I will upgrade the system to 24V

Hello Steve Thank you for your comments. I have a system with electrodacuds and I am also satisfied. Now wanted to upgrade my cells from 6 to 8 mm bolts because the first installation have shown 6mm weaknesses. According to load table for aluminum 30x5mm should be enough for 320A my induction...

it's a 2P4S 8cells 12V 560AH 400A is the maximum load 250-300A is the maximum load every day to cook in a RV 300A x 30% reserve = 390A

Hello Can I also just use aluminum busbars? Are 25x5mm cell connectors for 12V battery 400A maximum load sufficient. Or must I necessarily use copper. thanks

Hello can I also install the EVE 280AH LIFEPO4 cells horizontally without problems? thanks

How can i buy dmppt 450

Hello, has anyone already performed a complete load test on the two cells? would like to order with now 8x 280ah but I am not so experienced in LFP. if i read the special fications this way i would think the lists are a bit worse. What do you think? best regards Max