Search results

I feel like an idiot but I must be the only person in the universe that can't find a single piece of information how to get a firmware file update from a laptop to an EG4 8kw inverter. I see a hundred folks saying they've updated their unit but no says how. Is an EG4 app required? Which port on...

Still running 2 8kw inverters in parallel for a little over 4 months and doing ok. When first started up, each inverter's charging current was set at 25 amps. Over time I kept increasing the charge current setting by 10 or so amps and they both increased until they hit 50 amps apiece. After that...

Solar Assistant rep showed me a photo of a customers "connection". I guess it works.

I've had the inverters running in parallel and off grid since March. They've been doing ok. They did turn off and reboot one night during a very bad lightning storm. Did have EMP shield modules wired in case of lightning strike. I've had to switch the house over to grid a couple of times when...

Just used an old RJ45 cable connected to the CAN BMS port (lower left) on the 8k inverter and the CAN port on the EG4LL battery

Yes the EG4 batteries use CAN protocol when used with the EG4 8k inverter even though in the EG4LL V2 battery menu EG4 is listed under the RS485 protocol. Megarevo and Deye are listed under the CAN protocol which is actually who makes the 8k. Apparently the 8k inverters were looking for the...

I have installed a system with 2 8kw inverters planning to run in parallel eventually. I have 2 battery packs consisting of 6 EG4 lifepower's and 4 EG4LL V2's. I cannot for the life of me make either inverter start up and communicate with any battery. Currently have each inverter (not tied...