Hey guys. I have 16 280ah EVE cells arriving on Wednesday. I want to test the capacity of each individual cell before I put them together into a 16s bank. I was planning on buying the 150w capacity tester Will recommends from Amazon. If I fully charge a cell to 3.65 volts and set the capacity tester to 140 amps am I correct that it should take 2 hours to pull the full capacity of the battery? (assuming they can deliver 280ah). Four hours if I set the tester to 70 amps?
Can I harm these batteries by taking them down to 2.5 volts for the test? I don't plan to ever charge them to 100% or take them down to 0% once they are installed. I will probably never take them below 20% or above 90% and more like 50% - 80% during the Summer, late Spring and Early Fall (off grid solar place).
Thanks for any advice.
Can I harm these batteries by taking them down to 2.5 volts for the test? I don't plan to ever charge them to 100% or take them down to 0% once they are installed. I will probably never take them below 20% or above 90% and more like 50% - 80% during the Summer, late Spring and Early Fall (off grid solar place).
Thanks for any advice.