-
-
MMrPablo reacted to virus100b's post in the thread JK-BMS-CAN with new Cut-Off Charging Logic (open-source) with
Like.
I think your setup is missing the terminal resistor. Maybe Atom CAN has no termination resistor and the battery has one. A can network... -
MMrPablo replied to the thread JK-BMS-CAN with new Cut-Off Charging Logic (open-source).You can use either Pylon or SMA. I recommend SMA for the Solis inverter, mainly because Solis apply some Pylontech specific logic for...
-
MMrPablo reacted to RostadKatt's post in the thread JK-BMS-CAN with new Cut-Off Charging Logic (open-source) with Like.
Been running flawless for 48hours. Thanks for all the assistance in this thread, Sleeper85 have done a tremendous work here.👏🤜 For the...
-
MMrPablo reacted to Sleeper85's post in the thread JK-BMS-CAN with new Cut-Off Charging Logic (open-source) with Like.
This shouldn't be a problem, I work with 2.4Ghz and 5Ghz WiFi with the same SSID without problems. The ESP32 works in 2.4Ghz, they will...
-
MMrPablo reacted to Sleeper85's post in the thread JK-BMS-CAN with new Cut-Off Charging Logic (open-source) with Like.
Fortunately not all of them, mine displays an uptime of more than a month, date of the last flashing. 😎
-
MMrPablo reacted to chaosnature's post in the thread JK-BMS-CAN with new Cut-Off Charging Logic (open-source) with Like.
1st YouTube Vid on the Solar project - Next should be better and more detailed...
-
MMrPablo replied to the thread JK-BMS-CAN with new Cut-Off Charging Logic (open-source).There's no reason you can't test out v1.17.5 and disable Auto Voltage Control, it will still send static voltages appropriate to each...
-
MMrPablo replied to the thread JK-BMS-CAN with new Cut-Off Charging Logic (open-source).57.4v is a high charge voltage assuming a 16s battery. General guidance is to bulk charge at 3.45v per cell, so 55.2v. This will give...
-
MMrPablo reacted to shvm's post in the thread JK-BMS-CAN with new Cut-Off Charging Logic (open-source) with Like.
Also, if it bears mentioning again and again. When there is current going in/out of the battery, its balance can't be determined due to...
-
MMrPablo replied to the thread JK-BMS-CAN with new Cut-Off Charging Logic (open-source).Hi @paulsteigel, the existing auto charge current control does similar to this already. At the moment, we're working on controlling...
-
MMrPablo reacted to upnorthandpersonal's post in the thread Victron is Over-priced Eurotrash. Why would anybody buy Victron over an AiO? with Like.
Inverters 101 There are a few ways to make an AC voltage out of a DC source. Traditionally, these are (skipping modified sine wave) low...
-
MMrPablo reacted to silverstone's post in the thread JK-BMS-CAN with new Cut-Off Charging Logic (open-source) with Like.
@MrPablo: Actually I take it back. The default value of 2.0 didn't work at all for me (it actually went "full" power and caused cell 11...
-
MMrPablo replied to the thread JK-BMS-CAN with new Cut-Off Charging Logic (open-source).If you are charging at a higher C rate (which a max of 180A would suggest) then yes, charge_v_factor_setting can be set to be more...
-
MMrPablo replied to the thread JK-BMS-CAN with new Cut-Off Charging Logic (open-source).Yes please.
-
MMrPablo replied to the thread JK-BMS-CAN with new Cut-Off Charging Logic (open-source).Thanks @silverstone, hopefully the new auto voltage control will make it easier for you to keep your battery balanced.
-
MMrPablo reacted to robot_zombie's post in the thread JK-BMS-CAN with new Cut-Off Charging Logic (open-source) with Like.
I just want to say... thanks for all the work by the devs. Been running this since the early UKSA versions, and was sad to see it go...
-
MMrPablo reacted to silverstone's post in the thread JK-BMS-CAN with new Cut-Off Charging Logic (open-source) with Like.
Now I'll have to try to backport the Auto Charge Voltage Control as well :ROFLMAO: . EDIT 1: @MrPablo: I probably didn't mention often...
-
MMrPablo replied to the thread JK-BMS-CAN with new Cut-Off Charging Logic (open-source).I don't think it's best to leave the old logic in, no. Supporting two sets of logic is more work, plus testing indicates this solution...
-
MMrPablo replied to the thread JK-BMS-CAN with new Cut-Off Charging Logic (open-source).V1.17.5 has been released on GitHub: https://github.com/Sleeper85/esphome-jk-bms-can Changelog: - Auto Charge Voltage Control function...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…