-
-
7740GLE replied to the thread Multiple cells failures and bad experiences from DIANKAISHOU Battery Store.So in the mean time if you can source a BMS, you can run it as a 15s battery, while you wait for a cell.
-
7740GLE reacted to o0ragman0o's post in the thread Multiple cells failures and bad experiences from DIANKAISHOU Battery Store with
Like.
Thanks for the point responses. I'll accept this as the best and most likely explaination of the failure. What you've said has been... -
7I have had them on the shelf for almost 3 years… seen them all I need to. The boxes provide a better use of space, offer more...
-
7I designed them. Ordered cases from aliexpress. Ended up getting them for $220 each delivered. Ordered pre tariff. Good luck getting...
-
7740GLE reacted to Andrewr05's post in the thread Victron is Over-priced Eurotrash. Why would anybody buy Victron over an AiO? with Like.
Please help. I keep buying batteries when they're on sale! 🤣🤣🤣
-
7740GLE reacted to agtcovert's post in the thread Victron is Over-priced Eurotrash. Why would anybody buy Victron over an AiO? with Like.
This is the way.
-
7740GLE replied to the thread My DIY Battery.Nice bus bar covers, you design the file yourself or you find it somewhere? Where did you order the case from?
-
7740GLE reacted to adobopr's post in the thread Easiest way to top rebalance DIY LFP Battery with Like.
My current plan is to try this active balancer out and get them all to 3.6 and consider them top balanced, then let the Daly BMS handle...
-
7Thanks guys. Yea it's making sense now. My mind is stuck on household wiring lol. I think I'll go with 10 guage so I don't run into...
-
750 ft is a very short distance. I would suggest 10 awg as it gives you options to go with higher current in the future
-
7740GLE replied to the thread China Halts Rare Earth Element Exports to USA. Here we go...like the CFPB? And other “regulations” that have been walked back in the past 3 months?
-
7740GLE replied to the thread Epoch 12V/460Ah IP67 after two months. Balancing: Oof!.Hopefully balancing isn’t SOC based but cell voltage based. What’s your absorbtion voltage setting? 14v? I’d say bring it up and see...
-
7740GLE reacted to Koyaanisqatsi's post in the thread Epoch 12V/460Ah IP67 after two months. Balancing: Oof! with Like.
I can't stand having to use FB as a support channel. Never been to their page and never will. It's like the BMS software only running...
-
7740GLE reacted to Rocksnsalt's post in the thread Epoch 12V/460Ah IP67 after two months. Balancing: Oof! with Like.
Btw got the first Vatrer to 100% soc, the balance feature seems to self activate at around 98-99% soc. I reduced the charge rate to 2a...
-
7740GLE replied to the thread Remember when cell phone bills were per minute?.That’s where residential demand charge seems more applicable for cost sharing. You require more from the grid you pay for it. The grid...
-
7740GLE reacted to Tulex's post in the thread Remember when cell phone bills were per minute? with
Haha.
I pay $23 just to have service. An additional $1.01 for being billed, and they won't let you not be billed, I asked. So, I'm $24.01 in... -
7740GLE replied to the thread DC breaker: how many poles?.So a 3s, that’s about 70v and 10.7a going to the SCC. A 15a breaker is more than enough. As for gauge wire depends on the length of...
-
7Single pole is fine for OCP (over current protection) . But a disconnect should be 2 pole. A disconnect should open (disconnect) all...
-
7740GLE replied to the thread Remember when cell phone bills were per minute?.Just be weary of income adjusted rates, you can afford xxx you pay xxxx. It’s been talked about, looking at you California!
-
7740GLE reacted to HRTKD's post in the thread Remember when cell phone bills were per minute? with Like.
Being highly regulated, I sometimes feel sorry for the power companies. But not sorry enough that I won't be putting up as much PV as I...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…