I am to buy buy 8 batteries for my soalr system. I have a schneider 4048, outback flexmax 80 and 12 320 solar panels. What type of battery would you recomend?
And please what is 100 AH, 200 AH, what id the difference?
I don't use my system during the night its just a backup, I do use it only in daytime at 6 pm I turn of AC SUPPORT AND INVERTER. after that 6 battery voltage will go from 54 v to 48 volt in seconds. And there are times in which in a sunny day the system will simply not work. At night I am...
Got and schneider 4048 inver, 12 320 solar panel ,8 renogy 12v 200ah and an Outback flexmax 80. Even when the inverter is off we get sudden electricity loss in our home. Batteries go from day light 54 v to 49 at dawn. Please help.A t my age my technical skills are limited.
I received your message, thanks. But I have a doubt and that is that I have a 12 volt AH 200 battery and your message says 48 volt n=battery. Is the the sum of my fort row of batteries (I have got 2 row each with 4 12 volt batteries ).
I looked up the batteries parameters. I can't find or don't understand the TERM ABSORB I have been looking for it and can't find it . Does this term have another name? I also would want to know that once these changes are made in the controller, are there any changes that must be also made in...
In not a sunny day these are the reading in the out IN 118.8 V 1.8 A ,OUT 55.0 V 4.0 AKW 0.220 KW 0.9 KWH. The inverter reads as following BATTERY -2.9 A. 55.0 V, BATTEV E-F,LOAD 329 YY, AC1 247V. -183 YY. I hope this could help.
Inverter schneider 4048, OUTBACK FLEXMAX 80 FM 80 MPPT 80 AMP, BATTERIES ARE RENOGY DEEP CYCLE GEL 12 V 200AH.
As I said I tested the batteries and they are jus t fine. All I use the equipment is in the AC SUPPORT MODE during the day. The voltage will fall with no use from 51.1 (full) to 48...
I have got 8 gel batteries whoes voltage drop from full 51.1 volt to 47. i checked the batteries and they were at 12.7 disconnect. I keep them disconnected for a week and again checked them, they are ok. I have a schneider 4048 inverter, can anyone pleae help? . I think it a programming issue.