Recent content by Begginer7

I think that I will try to build a system that can support my existing AC pump, the pump has the following characteristics, is not the best picture but it says pump needs, 0.3kwh, I am assuming has a surge of 0.6kwh so I will install 2 panels of 425w each, total 850w, an inverter probably a 12 V...

I understand, in that case what brand or model would you suggest?

I am looking for a Dirty water dc 7m head submergible water pump about 800 GPH. Any suggestions?

Is there a solution?

Yes Epever confirmed its cumulative, needs to be reseted.

I have not tested with voltmeter, at the moment is night time here, if the mcb does not work as we wired it it would mean that we are shorting the panel connecting the pos with the neg. but note that actually the battery is charging very fast so I dont think is generating only 24W.

Great I was watching this video that said that equalization should be turned off and thought that I had damaged the battery by leaving it at 120m. Is the boost the same as float with ankther name?

At the moment the equalization time is set at 120m, should this be 0 for lifepo4?

When we wired the mcb as the sign shοw, that is crossed positive from left to right and neg. from right to left the mcb would not switch the panels off, it only worked when we installed it as its shown in the picture. The voc of the panel as per the manual, never tested is 48V. The scc is...

I dont have available a clamp meter only a voltimeter, yes the parameters are for 12V and bat. Is 12v: Something weird happened during the installation, the mcb that I am using as an on off switch for the panels was not cutting off so I asked an electrician who told me to ignore the signs and...

This is not the case with mine this number is not changing a lot whether batteries are full ot empty. Is this the sign of a problem?

2. Actually this number does not change much during the day so yes it was also measured at best sun. But something that is weird is that the value doesn't change to 0 even at night time, note the small moon on the screen. 3. I can only say the battery monitor was showing 100% but I do not know...

I agree the number must be wrong.

But does this make sense?, if its watts then its producing 24.5 watts per hour, so over the day 24.5x12= 294wh, no too low, it might be 245×12= 2940wh, makes more sense.

I think yes, however the wires had to be reconfigured due to a mistake on the wiring of the battery monitor and I am not sure if then the panels were shut off. But I have videos that show this high values even before this. Thanks for your advice its worth trying it.