Disturbedfuel15

If string voltage exceeds what a single pole can handle, multiple poles in series take care of it. Sometimes 2, 4, even 6 poles in...

I needed to cut metal better than using a hacksaw and I almost bought one of those chop saws. Got a band saw like you ahve instead. So...

Easiest to install in my opinion. Other than that, no reason. Both are certified not to leak so whatever was easiest and fit my budget...

Thanks for posting your configuration. This is good knowledge. I will say that I use both of those breakers as well. Same exact ones...

If those were mine, for each battery, I would use a midnite solar MNEDC250 DC breaker, then connect to the bus bar. They are pretty...

Thanks. I must be naive if you wouldn't mind explaining? I have five south bend 58v 150a mrbf, one on each battery (I'm sure you saw...

I'm a bit surprised nobody has left any comments. Oh well, I hope at least someone is learning something from this journey. It's been...

Its not the panel KW that matter but the total inverter KW but having E/W panels will drop the potential peak. My 230V SI5048 will take...

Amazing, thank you both @jpwhit and @kommando . I really didn't want to ship this inverter back across the country. So with that being...

I have two SB's set to Off Grid 50htz country grid code (UK grid is 50htz) and a Solax X1 Boost set to a country grid code that...

In this case you can just simply connect the L1, L2, N wires from the Sunny Island's output to the Sunny Boy Inverters. The reason it's...

Hello, I have two sunny island 6048-us with a 72kwh battery bank. JK inverter BMS is providing comms. Zero export set by data manager...

Op, I will go for 1 pls, bit long for my tiny sienna but I will use it as a ground unit for the Transit van.

https://www.pvxchange.com/Solar-Modules/Jinko-Solar/JKM-235P-60_1-2105663 Mechanical Data & Design Length (mm): 1650 Width (mm): 992...

Op, I am in GR but heading to Newark, NJ this weekend for a wedding. On the way back, I could swing by and pick up 1 or 2 for my sienna...

It was fun meeting you as well! I'll try to let you know when I get them up and running, but it may be a while.

Thanks for stopping by and purchasing a few @usherben . It was a pleasure meeting you and chatting! There are 30 left for anyone else!

Now to connect everything. I connected the four separated 4s batteries in the back with equal length 4/0 EDPM wire, tinned copper lugs...

I anchored 2x4s to the wall with concrete anchors. I finally got to use my Dewalt vacuum for the SDS hammer drill. Holy smokes, it is...

I bought five JK pb2a16s20p back in... November I believe. I have to sell my old ones. I'm noticing a pattern of me purchasing twice...