That looks much like ours. 8 loops on a 53 gallon domestic water tank(nat gas). Kitec loops, grundfos pumps. 25 years and going strong. Nothing like stepping on a warm floor on a cold winter day. Those that have never experienced are minus a great luxury!
It did. It was like pulling teeth to get a RMA. I requested either repair or replacement. When I got in touch with a live person, I was told that a refund would be issued. I re-stated that I wanted a replacement and one was sent. Once the "non gray" areas were understood, it arrived in...
Just checking in to see if anyone has had issues with a refurbished purchase. I acquired an EB70 that worked flawlessly for a number of months. The screen went blank and it quit working normally. After numerous attempts I received a RMA for return/repair. I was told that the battery bank was...
Requests were made through both email address's(Maxoak and Bluetti). I got in touch with an individual at the Maxoak sales phone number and was told to correspond with the Bluetti email address. The unit was purchased through Maxoak. It was sent from Bluetti Power Inc. in Las vegas.
I am looking for suggestions to remedy a partially working EB70. I purchased a refurbished unit and the screen has gone blank and the AC side shuts down immediately after turning on. I have made 4 attempts, through "service@bluetti.com", to obtain a RMA approval for return to repair or...
My EB70 just arrived. Red, original box with all the accessories. It looks like it was new in the box. It was low on charge(AC charging now). The only thing out of order was the AC cord. It was twisty tied, but not tightly wrapped. I am happy with the purchase. Thanks Maxoak........A great...
Blue,
I am in the process of installing 36 Heliene 360w panels(12.96 kw). My setup: three arrays of 12 panels( 1 array South, 1 array West and 1 array east). Each to an older SMA sunny boy 4000us(3 in total). Grid tied with Tigo rapid shutdown. Took 3 months to get utility approval. I am in...
I am going to start my install on a metal roof(pro panel, mage bracket). I am looking for junction box ideas. I am shooting for something that will be under the array. My roof penetration will be with a Zillarac passthrough to 3/4 EMT conduit (...