Gurusi's latest activity

After further troubleshooting it turns out the contactor on the water heater smart switch was faulty (making a whining noise when...

Could be the Panamaz has stopped too many spikes, and has become too sensitive (kind of like a breaker). It senses the line fault too...

There have been threads about bad waveforms, and some about suspected equipment damage. So it is possible the Panamax is just the canary...

Thanks for the links, I will buy some. Yep agreed an oscilloscope will be best (but I’m not considering buying) as not changing...

I have watts set for daily checking, see attached but only shows a volt difference. I have the midnight solar ones for the PV inputs Do...

Definitely put that projector on a UPS if it's using a lamp and not a laser light source, uncontrolled shutdowns and frequent cycling...

It briefly clicks on and off within a second. But I don’t believe it has been actively protecting often as we haven’t been using the...

Sounds like it was doing its job - saw over-voltage and opened a relay...

I’m guessing I would need an oscilloscope to know? Attached is a read out from my emporia app at times of cut off. I would rather add...

I installed it, all as should be neutral grounded etc. it’s running on a 15amp breaker with two other outlets that have nothing plugged...

The resistive load made no difference; however I did confirm that the Panamax MIW-POWER-PRO-PFP is the culprit. I got on a ladder and...

Maybe put a small resistive load (100 watt lightbulb) on the same circuit as the Projector. Either before, or close to, the Projector...

Surge suppressors are only for spikes to hundreds or thousands of volts. If you had a scope, you could capture waveform triggered when...

Yep, I think you have methods of resolve listed. I find the line conditioner the simplest and most protective for the projector. But it...

Projector is direct from 120v. Unfortunately it’s the furthest point from the inverters with no direct DC line.

I think you may be correct with the load dump either spiking on return or maybe the sag causing shut down. I am apprehensive about...

Good to know, I was unsure if a soft start would be of benefit for the heater/hottub element. Currently I have smart switches on 240v...

It is the monitor that cycles. The cameras and the DVV seem unaffected. I just ignore it now.

It is strange. Did you find a solution or just let the cameras power cycle?

Likely you would need someone like RichinFL to explain it. I just know that some strange oddities happen with certain electronics and...