diy solar

diy solar

Most reacted posts

  • Post in thread: Limiting solar voltage to 60V at 500W

    Thanks. I'm using Renogy 100w panels with an open circuit of just over 21V. Unfortunately this is just over the 60V input limit of the Bluetti AC180. I was hoping the 60ft of cable would have enough of a voltage drop to work, but that's not the case. Later in the day I'm going to reconfigure...
  • Post in thread: Bluetti AC2A and my experiences so far.

    I have a Bluetti AC2A and have been using it for just over three weeks. I use the AC2A as a backup device for small power tools and I’ve tested as a UPS for my home office. For yard use I have 2 100w Thunderbolt solar panels wired in parallel on a movable cart. I can’t run these in series due...
  • Post in thread: Bluetti AC180 x 2 14 Renogy 100W Solar panels and my experiences so far.

    I have 2 AC180s and have been using them for just over three weeks. I use one AC180 to run my home office and to power a chest freezer when I have spare power. The other AC180 is on standby for power outages. I plan to swap both units occasionally to even out the wear on the batteries. I have...
  • Post in thread: Limiting solar voltage to 60V at 500W

    Thank you
  • Post in thread: Limiting solar voltage to 60V at 500W

    Thank you
  • Post in thread: Limiting solar voltage to 60V at 500W

    Is anyone aware of a DC to DC converter that can take a max input of 65V and output no more than 60V? I'm using a Bluetti AC180 and trying to input up to 60V at 8A into it. Thank you
Back
Top