Recent content by jamesnewman01377

Thank you, I will try to charge individual cell to get them back on top, would you change any of the settings, they’re basically factory default settings, I haven’t changed anything. And when do you configure the shunt?

I have stop charging for now, and I’m not using the inverter to charge, because I haven’t completed my Solar set up, i’m just using one of them chargers from signature Solar, I was just checking to see if all the cells were good and if the Batrium is working right. I might be going at this all...

I’m not what you mean about SOC, if your meaning the state of charge when I started out, they where about the same, about 3.58 to 3.73 from the lowest to the highest, and probably should had them all paralleled so they would had time to get to know each other before I started to change them.

I’m using SPIM08HP 3.7v 16AH cells in 15P x 14S configuration from Battery Hookup. And yes everybody can fuss about me using these batteries, but it’s what I got.

Can someone help me with my Batrium setup, my cells seem to be a little out of balance, I may not have the parameters right or something, I have a few cell over there limits and they just seem to go up and the other cells haven’t caught up.

Thank you again, a lot of help, great video! If I’m doing this right, where you would put in your capacity, each of my cells are 8.5 Ah and there’s 30 in parallel, I would in 255Ah, if that’s right?

Thank you, it works, got it downloaded and updated. I have to finish my wiring and install the core back in the box and plug everything thing in and go from there. I haven’t found a really good video on the WatchMon Core with the CellMate K9 yet.

No security risk that I can see, doesn't seem to do nothing when you click on the link and yes V 2.17.15 and I tried 2.19.9 earlier release.

I have a Batrium Core, I need some help, I can't download the program that run Batrium, I have three computers and none of them will download the software. I have been working on this for hours, can't seem to get anything to work. Please help a computer idiot!

Do you think eventually I could took all 3 48v pack together on one inverter? And how do I figure out how big of a main fuse do I need on 48v pack? Or am I overthinking it, I figure each main battery cable needs some kind of protection. I built performance cars I’ve got fuses on everything.

100p14s, an each cell is fused with 5 amp glass fuses, I did build them similar to the Tesla Pack, mainly watching YouTube videos like average Joe and a lot of others. There wasn’t much to do between all this Covid stuff and cancer. I’m using the Batrium WatchMon Core with the K9, and thank you...

Each cell is fuse with a 5 amp fuse before the bus bar.

And I know now I have wasted a lot of money Messing around with the cell, but I would like to see them work a little bit.

What do you suggest to test these batteries, the one bank of 18650s 14s100p is brand new cell, LGDBHE41865, I tested each one, all were around 2600 to 2690, they are getting to be about a year old. I see people testing as a module of batteries with like a icharger x6 to see what each module...

I’m not sure how to calculate the capacity of the 18650s, haven’t gotten everything finalized, the 18650s is just what started with last year and just finished putting them into packs and gotten hung on the wall. The SPIM08HP modules are originally 36v, you have to rearrange the cell to build a...