-
-
JBertok replied to the thread My DIY XW Pro System.Okay, so the XW is ramping up load faster than the generator governor can compensate. The loss of AC2-qualification would be from the... -
JBertok replied to the thread Help please schneider combox.Been a while since I've used one, but I recall a few things... Assuming that you're no longer able to access the web interface since the...
-
JBertok reacted to Helidriver's post in the thread Post Battery Bank and Inverter! (pictures only) with
Like.
-
JBertok reacted to Tulex's post in the thread Post Battery Bank and Inverter! (pictures only) with Like.
In unfinished utility room that wasn't intended to have solar. Panel box covered up as nobody should see that temporary mess.
-
JBertok replied to the thread Question about Schneider XW Pro's abilities.*Subscribed* Also interested in hearing outcome...
-
JBertok replied to the thread Inverter Bypass.A few capacity considerations: - The double-pole circuit breaker capacity in your meter panel "Grid 1" feeding this circuit needs to...
-
JBertok reacted to chicagoandy's post in the thread Post Battery Bank and Inverter! (pictures only) with Like.
-
JBertok replied to the thread Solar not supplying to mains before battery is full.It sounds like it's still going into Low Battery Cut-Off on the inverter. Since you're seeing 44.9V on the system when the error is...
-
JBertok replied to the thread Charging one battery out of 16.Okay, so that model you got is very strong. You'll need to watch the amperage because it can push a Lead-Acid battery well past...
-
JBertok replied to the thread Charging one battery out of 16.It works but noticed it detected the battery as 12V instead of 6V. It's pushing amps, so that's a win.
-
-
JBertok replied to the thread Charging one battery out of 16.The Schumacher one I've got isn't specifically made anymore, but Schumacher still makes current models the same way. They are...
-
JBertok reacted to BentleyJ's post in the thread EG4 6000XPs to replace a Growatt SPF 12K with Like.
IMHO you are overthinking things. Install the Soft Starter and replace the failed inverter with a Sol-Ark or an 18kpv. If you are...
-
JBertok replied to the thread Charging one battery out of 16.I've been topping off individual Lead-Acid 6v batteries in both 12V and 48V configurations with a brute-force automotive transformer and...
-
JBertok replied to the thread Battery as PV Input for MPPT.I would think the MPPT has to specifically support doing that. The ones that don't list voltage and current limits separate from its...
-
JBertok replied to the thread Schneider xw pro 6848.Cool, if possible then, push the charge upward with the grid if you have to, and let them get to a point where they can spend 2 hours...
-
JBertok replied to the thread Inverter Bypass.Spot on. That's perfect.
-
Excellent.. thank you for this feedback.. and appreciate all the responses thus far.. your recommendation is to build to the following...
-
JBertok replied to the thread Schneider xw pro 6848.Okay, that indicates that the BMSs aren't getting enough time above 54V and 95% SoC to perform self-calibration. You've got some...
-
JBertok replied to the thread Solar not supplying to mains before battery is full.Okay, you've got a PV1800. In parameter #19, that one gives you the ability to stop inverting at a set low voltage. I did see you're...
-
-
JBertok replied to the thread Place grid-tied solar inverters in series?.Well you came to the right place. Nobody's going to waste your time and money here, or at least get away with it.
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
