Recent content by Justdr5

DM sent. Thanks.

It's been a while, but I used the eg4 youtube guide and it says CAN. Hard to tell which protocol from this screen as both show up=)

Hi I have been seeing this strange behavior and wanted to check if anyone else is seeing something similar. Recently, the 18kPv just stops charging the battery well before 100% SOC and just kind of sits there for 20-30 mins. There is not a cloud in the sky nor any shading and the inverter...

Got any pics? Was looking at integrating Tigo devices into my system and I am easily sold by pretty pictures and diagrams=)

I was troubleshooting this for hours today. Just saw on a social media post that there was an issue on the EG4 monitoring side. Is anyone aware of a status page or anything we can subscribe to for outages?

Yes the problem was that I was showing values which where waaaaay off. Most of my loads are resistive so to see such a huge difference between measured and displayed was confusing. Looks like the default for my CT ratio wasn't correct. I do not know anything about CT's but I assume it has some...

Yeah

It seems much closer now. Off by 10% or so instead of 80%=) Credit points distributed as follows: Nuke=2, Zanydroid=2, BKY2003=1, Quattro=1. Appreciate your help all.

Thanks. got it.

ok so I found the PW in the manual and swapped to 1/3000. Seems closer to reality now

Negative. Mine is 1/1000. I do see in the manual the default on these should be 1/3000. There seems to be a pw required to change this value though.

So tonight I had a heater running plus my normal ~1k draw for a total of ~5k. The 18kpv shows 1600W. I also pulled each CT off 1 at a time and the power draw changed to ~800W total when taking off the L1 CT and ~800W when taking off the L2 CT. The CT Power offset seemed to have no affect on...

Yah im on a 50amp breaker. Thanks for the double check though. Never hurts.

Yeah this confused me as well. Going to hunt around as the offset metric info wasn't included in the manual. Thanks.

Firmware up-to-date. 6 gauge wire isn't sufficient for 50A?