Most reacted posts

Hmm, I’m not sure I agree. The valence software has been communicating this whole time and indicates that balancing is active. I’ve watched the other 6 batteries balance out and seem to be working just fine but the other two are stuck on one individual cell bank. The batteries themselves stay at...

That's good info, Stiffmeister. Thank you. When I started observing my problem I dropped the limiter all the way back to 60 amps and was still having the issue. Since my initial post I have upgraded the breaker from the cheap marine breaker that I linked to and replaced it with a 100 amp...

Things seem to be going ok. I don’t run my batteries down very far so the load on the charger stays low. When it does need to throw some power the fan kicks on so my assumption is that it is working hard. I don’t think the 125% figure was used. My panels ISC is 9.5 amps.

About 2 ft. of 3 ga.

Hi, I live off grid and constantly trying to upgrade my system for improvements. I've been using Outback's Flexmax 80 controller, and recently upgraded to (8) Valence U27-12xp lithiums in a 24v arrangement with (9) 280 watt / 38.5v panels configured 3x3. Mosts of my loads are small 12v and 24v...

The breaker is 80 amps. The 60 amp I referred to is the limiter function, first option on the charger settings, before bulk and float voltage settings.

Thanks, I thought I posted my setup early in this thread but maybe not. Yes, I wired to bus bars.

98v, 11 amp IN 27.6v, 36 amp OUT