Recent content by Partsjockey

Bought EBC-A40L I can get it to charger & discharger a cell, BUT I can't seem to figure out how to save the test I'm doing so I can look at it later when it is done not 3 am lol. Any help would be great. Tia.

ok

So lets just do the basics. If you disconnect your Lithium does the alternator go wacky?

You have a picture of your setup in the engine bay?

It should have a part that takes the 24v and splits down grades it to 12v. I will take a picture of my electrical bay later on today of my bus which is an MCI but similar to Prevost, and we can go from there. Ok!

I would say it is 24v.

Best bet phone prevost w/vin they will tell ya what voltage it is.

I purchased 16 cells from Docan Power through Amy in May of this year received them end of June I believe. Have tested all 16 I have 4 that are defective ( 2 really blotted and 2 others that are blotted but one bleu the vent and the second one wasn't far behind. I had to bring these 2 cells up...

Like the title says but here it goes. I have a JK-B2A24S15P that has 2 7mm wires for -B & 2 7mm for -P can it join the 2 -B and use just 1 terminal? Inquire minds would like to know.

Would have been nice to be warned not to change them. I'll try to get hold of 18650 Battery see what they say. It's been very trying to get through there tech support.

no swapping of passwords. the password I used is fairly generic to me

Good day people, I will try to keep this short. I purchased 3 JK Bms from 18650 Battery Store. 1 JKB1A8S209 and 2 JKB2A24S15P. I'm not sure which one or possible both JKB2A24A15P I'm having issues with. 1 I have renamed (inverter 1)but not changed password the other I have renamed (inverter 2)...

So mine is very close to that, the only difference is the cell ovp & ovpr I had mine higher will more than likely bring them a tad. What kind of RV do you have? Thanks for the info.

JK B2A24S15P

Have a RV that I'am changing batteries from AGM to Lithium. My inverter is 24v, charging w/shore power or Gen set no Solar yet. What would be everyone's recommendations on setting up the BMS?