Most reacted posts

Ok, right now my Growatt settings are 19 = 57.60V 20 = 57.60 21 = 42V i will change this to above ratings and see. bleed down the high cell i can use a 12V car light with some croc clips. do you have a product link to the 16Cell 48V balancer? Thanks

Attached image for discharging- Is this mean need bottom balance Current status 19 - 56.2 20 - 56.2

Or buy one of those active balances would do the trick? Since the pack is assembled now

Completely different question I have 2 Growatt 5000es with 5kw (105ah x16) and 8Kw (16x 166ah) battery pack What’s the best way to connect in single phase ? Remember it’s different capacity batteries

Due to couple of cells low voltage complete battery pack can not use hitting the low voltage trigger from BMS What should I do to balance this

Hi Didn’t have to bleed the cell down. After changing the voltage to 53.80 all settled. Now settings are 19 - 55.2v 20- 55.2v Question remain same Why the batteries are not charging up to 3.6v

Thank you, now I know if I increased the charging voltage from Growatt then cells should charge high. I’ll test that If you see the above image, it’s showing pack is discharging at the rate of 1.0A or below So why is that? Why can’t the battery pack stay 100% after full charge ?

HI i got Eve 16Cells with Xiaoxiang BMS have some issues 1) everytime when i charge batteries, the pack don't charge to 3.4 or over. but sometime single cells go over 3.4V. i'm sure this has to do with my BMS settings. 2) or do i have to charge over 3.4V and go up to 3.6V to get the...

thank you for the reply on the app where to reduce charging voltage to 53.80 ?

is this ok? can you share your settings page. i have some similar issues.