Recent content by TellGRBill

I would like recommendations for powering a 1/2hp 220v submersible water pump in a 95' deep water well with 12v battery bank. We have a split phase 220v electric system.

I have decided to attach an alarm to the A30-U3 voltage monitor we bought that has a relay to either activate a shutdown device or activate a warning light or an audible alarm. I have purchased an audible alarm and alarm shutoff switch, and will see how this will work for us. I found a relay...

I would like to attach my LVD monitor onto the shutdown switch without going into the circuit board of the inverter, and also have the use of the manual shutoff switch.. I hope that there is a way to do that. With directions to wire the LVD monitor to the switch wire I would try it. I'm afraid...

Sorry for my uncharitable comment Mike. The BMV 712 is a battery monitor. It computes battery state. It has an internal relay that could be programmed to disable, via the remote switching, your inverter at a chosen SOC. [URL unfurl="true"]

I didn't comment on this forum to be approached by a sales person for some other inverter. I posted to see if I could get advice for using the inverter that I already have.

I have a battery bank of 10 group 31 deep cycle truck/bus batteries and I believe that 10 volts would hurt the batteries. I would like the inverter to shut off at 12.3volts I think. I still have several 12 volt items that run on 12 volts, so we would not be completely shut down while we wait...

I have read the manual but can not find any instructions to adjust the low voltage disconnect. I have bought a voltage monitor DC 6~80V Voltage Monitoring Relay Time Delay Relay Charging Discharge module and could connect it to the inverter. This inverter has a remote controller to shut it off...

I would like to know if a 12volt 3000watt Renogy inverter can be set to shut down at a specified low voltage level. If it can be set to shut down at a specified low voltage level, how can I set that voltage level on this inverter?