Recent content by texskeet

300 cells my as I had 64 just me.

On sight

user manual

guess I will solder wire ext to the last 3 cells. Will that work?

They will connect only 13 cells. Just should work like the drawing on the downloads.

48 volt overkill the cell leads are to short to mount the BMS on the end like the picture is this right? I built to mount on end now will not work.

I said gas they run gas plants below max to have somthing for outages and such. There is little coal around me so don't know All wind and solar is 100% all the time no way to make more.

The point is when it gets very cold you need more power and wind and solar can't go up because they are at 100%. The higher % solar and wind the less flexable the power production .

This guy is not right. 1. nat gas doubled its out put of power in the big Texas freeze. 2. there were problems or they would have more than doubled there out put 3. Wind and solar production went down. 4.If wind and solar are to do there part in a big freeze if you put up 1 wind mill you would...

Where can I buy a 12 k sol ark cheep ?

may be just buy the whole reailer.

Those bankrupt batteries would work great bet you can get them cheap.

Use a qtip and put the loctite on the threads in cell then when you put them in loctite want get on the terminals.

One more thought,many of these cells are convex to start. when you apply pressure only the top bottom get any .pressure looks like the cell expansion is what applies the pressure, how hard will the cells be pushing on each other??? I don't think they will push that hard. snug them up and they...

Is this your top balance setup it is neat .