diy solar

diy solar

Most reacted posts

  • Post in thread: MPP Solar PIP-1012LV-MS Charging amps

    Guage of wire - 8 AWG (this matches the rv battery wiring which has accommodated a 55 amp charger just fine). Length of wire - 24 inches All connections are properly torqued Voltage at inverter terminals 13.48 Voltage at battery. 13.36 Interestingly, when both utility and solar are...
  • Post in thread: MPP Solar PIP-1012LV-MS Charging amps

    The setting changes were suggested by the vendor who sold me the unit in attempting to solve the problem. Since the changes did not solve the problem I’m going to change 26 and 27 to your suggestions and 12 and 13 back to default. I am using the system in an RV. I want to use the solar panels...
  • Post in thread: MPP Solar PIP-1012LV-MS Charging amps

    I just purchase a PIP - 1012LV-MS and was expecting to get around 20 amps of charging power while connected to shore power. The 280 a/h lithium battery is only charged 35%. The charger starts charging at about 17-18 amps (which is fine), but then cuts down to around 8 amps after and hour and a...
  • Post in thread: MPP Solar PIP-1012LV-MS Charging amps

    8.59 amps
Back
Top