It is a 48v 1050 ah at 6 hours, lead acid battery, but it fully charges fine with 5 KW of solar panels of solar. I worry that adding the extra will confuse the Sol-Ark scc? Or charge to quickly and shorten the life of the battery. I would like that battery to last 10 years. I have only been...
if I am feeding a 220 volt panel, does the sol-ark care that the neutral on the inverter is not being used? (110v not needed, no neutral wire) the panel is grounded at the panel and does not have a ground wire that runs back to the inverter? Thank you in advance for the help
Using a inverter without a battery is probably a bad idea because I have looked for hours and cannot find any information on it. The manufacturer said I could use a solar charge controller and a battery with it but it would need to be a 200v minimum battery. I like your buffer battery idea but a...
So here's my dilemma, it would be fun to set up a second system in the garage, with parts that have been gathering dust for a while. I already have a 48v 7,000 watt inverter and two Outback charge controllers, and a couple strings of solar panels. and two enormous 24 volt lead acid forklift...
This is probably a dumb question, but I spent 10 grand on this large lead acid forklift 1000 amp hour battery, that has no charge rate specifications. The manufacturer the battery simply says get the charge rate off the vehicle it is installed in, obviously it's not installed in a vehicle...
The ato 30kw inverter is designed to be used without a battery but can be used with a battery by running the battery terminals to the PV plus and negative terminals. The input voltage should be 200 to 600vdc. If from the battery or from the PV. I hope that's the information you're asking for
Can I put two 24 volt batteries in series to have 48 volts going to the inverter but charge them separately at 24 volts? The 24 volt batteries are similar but not exactly the same. Thank you in advance for the help.
I have 98 240 watt panels installed .seven strings of 14 panels, 465 measured open dc volts . I also have the largest Electric forklift battery I could find, but I'm open to other battery suggestions if necessary, I'm trying to decide what the best high voltage charge controller and inverter...
Thank you again for all the help you guys. Okay, so I've learned from you that going from 24vdc to 120vac and then back to 48vdc is inefficient but not that big of a deal. If I measure the power going into the charger it's 120 vac/ about 10 amps and when I measure the power coming out of the...