Sofar HYD EP Series

Looking to use one of these with a DIY Lithium in lead acid mode (which i run very successfully with my Deye inverter). However there's little in the manual about configuring the lead acid parameters.

Does anyone know 100% & can send screenshots if you can you configure:
- Charge voltage
- float voltage
- voltage disconnect/low voltage
- charge current
- discharge current

If it is not too late to asnwer your question, you can just configure the parameters for battery without communication system as written on the page 37 of the manual. And there is no setting for voltage disconnect or float voltage, just the DOD. I was using it this way few days till the Seplos BMS arrived for my LiFePO4... There is no better way to use DIY battery with Sofar inverters, get a Seplos BMS and set it up for Sofar, with all the detailed parameters you can imagine.