Search results

Greetings , has anyone ever tried to use lv6548 in the following manor , the system runs okay I have back fed a breaker that has a generator lockout to my homes panel , I thought that I could wire up some cords to the aux ac input where the genset would go into the inverter and charge my...

hi where do you install the cap ???

Hey , so where can you get the diodes , and did you repair the panels i would like to have some spares just in case I have qcell 480 bfg's myself ... I bet it was a chore digging out all the sealant for sure

well first time build here , my setup is two mpplv6548's with 4 sok 48v rack batteries and solar panels . My main service panel is at the road with two branches protected by breakers this panel has the n/g bond , my homes main panel is a sub panel of course with no n/g bond , I have a generator...

thnx for info , patiently waiting for my batteries ,cheers

greetings , does anyone have any experience with using the mpplv6548 with the new sok rack battery , do you need special cable that is not included with a new lv6548 to communicate with it ? thnx for any input

your amps are way to high for the rating of 18a per pv input

You are right about not achieving 8k with one inverter (rated@6500 max ) battery choice basically was chosen because of watching Will videos for some time , I liked it's features , and I needed simplicity instead of building one cheers

again my thoughts grounding is to protect the humans from being electrocuted

I'm starting with the two inverters for 240vac , I'm populating all four pv inputs with just four panels in series , then I have room for upgrades on solar arrays , I tried various panels in a series of 5 but couldn't get the maximum kw output without going over voltage with the coldest temp I...

my thoughts are your first panel that the solark is supplying power to, is considered main panel , therefore it needs to be bonded to the ground rods , and all other equipment should be bonded by a bonding wire to the main panel

I'm building the same with two lv6548 and bifacial panels and I directly asked mpp about the same issues and it was conveyed to me , NOT to go over the max voc , the amps are flexible , considering they require you to fuse the pv inputs with a 30 amp fuse max. what you have to include in your...

my local jurisdiction required me to drive 2 ground rods at each location of a sub panel even though all sub panels are bonded to the main panel , all the sub panels have isolated neutrals ,personally to me the bonding is what's important

okay another question I'm thinking that I should populate all pv inputs , instead of fully populating only one input on each inverter .then later if needed i can bump up each run , according to my needs your thoughts

yeah current is high , I emailed them and included spec sheet of panels and calculator result and they said okay on amps , more importantly to stay below voc.. honestly the results on the spec sheet are done in a perfect environment so i tend to think the nmot results are more of a real life...

yes

hi I'm building my first system , and I'm using two of the mpp-lv6548 it says 4000 watt max per pv input . i just want to check my reasoning to be sure i do this right. when i use midnite solars calculator , i can get close to 4kw with 4 - 480w panels in series @ two parallel strings per pv...

greetings I would like to install solar power on my home , grid tied . my quandary is that I have my 200amp panel on my home , but it is being fed from a 200amp Mobile home pedestal that has 2 circuits , one supplying my home the other supplying my shop , these buildings are at two different...