Search results

Thanks, I think sunshine_ego answered, and gave a pretty good technical explanation that fully answers what I was looking for. In my initial question, I stated I was testing max voltage output and did not have any load or batteries connected so the batteries in this example is not part of the...

Thank you for the reply, I thought so that makes sense. My 3-stage RV battery charge has a bulk charge of 14.82, so the PWM outputting 14.5 is not too far off. Re: 4-stage controller question. I do not see any additional technical specs on what the voltage output is on any of the 4 stages of...

Hello, I have a 100watt 18v / 5.56 amp hard sided portable solar panel and in full sun I only see a maximum of 14.3 - 14.5 volts. I can see upwards of 5.x amps when in good sunlight but no matter what I do I never see over 14.3'ish volts - without any load, I have tested using a volt meter via...

Ok - posting a follow up in case someone else comes across this thread and wants the power to run back through to your battery monitor. Shout out to sunshine_eggo for diagnosing my problem! In my setup, I have two 6v Trojan T-105s wired in series, and a AiLi Battery monitor wired using a shunt...

I think I may have found a diagram that shows what you are talking about... This look about right?

Hmm... so you are saying, I should take my negative and attach to the negative on the actual shunt? I had not considered that, and... since my shunt is attached to my A-Frame of the travel trailer I sealed it up inside a weatherproof box, so that would kind of stink. I would need to come up with...

Hi all! I have had the AiLi battery monitor installed on my RV now for going on 3 years and it's been amazing. Up to this point I have used it only with shore power, when we dry camp and use a generator everything works perfectly, the Volts, Amps, Ah and % has been dead on (based on my volt...