Search results

I have a repeater with the same ssid as the router and the esp has connected to the router instead of the repeater. I have specified the bssid instead the ssid and it works fine :)

Here’s what I fetched

Yes that's how I do but when I loose connection, there's no logs anymore ?

Hello i'm still having disconnection issues, but I can't figure out if it's wifi related or anything else. I don't understand this part, I uploaded the code through Home assistant ESP implementation ? If I activate the logs in the YAML there's really a lot of things reported so it's difficult...

Hello, there's a compilation error with ESPHome 2023.4.0, because of this modification : UART ids Due to uart0 / uart1 / uart2 being defined in some of the platform code ESPHome uses, ESPHome will now disallow these ids from being used in the config. You can simply change them to uart_0 to...

Yes, and RS485/canbus conversion works fine (updated really often) Where should I run this command ? I think it may be WiFi connection too weak. I'll try to move the access point. If you want to add to the compatibility list I have JK BMS JK-BD6A17S8P with Sofar Solar Hybrid Inverter...

Hello, I have problems with update rate in HA. Data are retrieved randomly (>20' sometimes), but RS485/CAN conversion is working correctly. Do you have any idea why ?

Hello, I can now confirm it works fine (had to remove the "latest" in the framework section to compile ESP Home.) If you want to add to the compatibility list I have JK BMS JK-BD6A17S8P with Sofar Solar Hybrid Inverter HYD-5000-ES (Firmware V3.60) in Pylon mode (US5000) Thanks a lot :)

Thanks I did not looked at the code, sorry :( Maybe the schematic on the github page needs to specify the pinout / colors? RS485-TTL RS485 RS485-TTL RS232-TTL CAN BUS ┌──────────┐ ┌───────────┐...

Thank you, can you confirm that on both sides, TX and RX are crossed between ESP32 and tranceivers ?

Thanks, I will post report once I have received everything.

Hello, I have bought a ESP32 Wroom, a DC-DC conversion module (to pull power from the JK switch/screen port), RS485 -> TTL converter, TTL -> CAN converter TJA1050. Can you confirm pinout ? From JK BMS with RS485 module Yellow -> A+, White B- and from the RS485 transceiver TX -> ESP32 pin 17, RX...

Thanls for the answers

I did not buy nor installed anything, so it's not easy to understand. Your interface interprets RS485 from JK and "translates" it to a Canbus protocol (Pylon 15S as said in the Github page or Goodwe 16s) Is Goodwe the same as Darfon, General, Alpha or Soltaro ? Also do I need a wifi connection...

I have a HYD-5000-ES. It supports Pylon, but as far as I understood, Pylon is limited to 15s ?

Hello I'm planning to build your project. Has anyone had any success with 16S and Sofar Inverter (so no pylontech protocol) ?