Trying to determine if using the LYNX and its MEGA fuse requirements, for my 24V system design is good/doable. 24V = smaller cabling which i like. Clean in/out of LYNX i also like. But smallest MEGA fuse i can find is 40A which = 10AWG, which is also fine. 60A MEGA/8AWG might be OK, but pushing limits on component connector cable size limits. 40A fuses seem relatively uncommon only one i can find is on AMZ https://www.amazon.com/2-Mega-Fuses...1647901151&sprefix=40+amp+mega,aps,200&sr=8-2 and doesn't list the voltage... I have searched here on the forum and found a couple of posts with one possible LYNX adaption to MIDI fuse's, but haven't found much else in anyone doing this 40A MEGA/LYNX combo. ANY help/wisdom/experience would be appreciated for this beginner. Thanks!