Brian Kloosterman

I unplugged it, but was still unable to change some settings…

Would this maybe be 35 and 37?

No, they are connected currently

Could you point me to this? I don’t understand what this is yet.

It will not allow me to change this setting either…

This didn’t work

Will I have to do that every time?

So disconnect the panels (only positive?), change the setting and reconnect the panels?

If it’s working, should I see the green arrows from the “grid” icon to the inverter?

I cannot change number 6, it will not let me…it’s defaulting to SNU. Apparently I need to be in bypass mode, which I know nothing about...

I’m running in USER mode…

When you know those settings (and the setting number would be helpful too) for certain, please let me know! Thanks

Also, after running my batteries down, I’m getting error codes 30 and 32…can/do I do something about that, or just wait for them to charge?

Your link takes me to a whole other forum, not your settings. Can you tell me what your setting 37 is set to?

I’d like to set it up where I can start the generator if the batteries get low. I only temporarily have 10 panels hooked up, using the...

I can’t find those posts, maybe it wasn’t you. But yes, I need to charge my batteries using my generator, via the ac put on my inverter...

I can’t find those posts, maybe it wasn’t you. But yes, I need to charge my batteries using my generator, via the ac input on my...

Kenny, you had previously shared with me what your settings were (see photos). I want to charge my batteries with my generator. What...

Thanks guys. Sungold’s instruction manual leaves quite a bit to be desired…

33! That immediately got rid of the error! What does Pylontech refer to?