Search results

I unplugged it, but was still unable to change some settings…

Would this maybe be 35 and 37?

No, they are connected currently

Could you point me to this? I don’t understand what this is yet.

It will not allow me to change this setting either…

This didn’t work

Will I have to do that every time?

So disconnect the panels (only positive?), change the setting and reconnect the panels?

If it’s working, should I see the green arrows from the “grid” icon to the inverter?

I cannot change number 6, it will not let me…it’s defaulting to SNU. Apparently I need to be in bypass mode, which I know nothing about x Also, I don’t even see SUB as an option. Did you mean CUB?

I’m running in USER mode…

When you know those settings (and the setting number would be helpful too) for certain, please let me know! Thanks

Also, after running my batteries down, I’m getting error codes 30 and 32…can/do I do something about that, or just wait for them to charge?

Your link takes me to a whole other forum, not your settings. Can you tell me what your setting 37 is set to?

I’d like to set it up where I can start the generator if the batteries get low. I only temporarily have 10 panels hooked up, using the “solar first” settings, so when the RV is running the a/c and whatnot, there’s not enough juice to power the rv AND charge the batteries too.

I can’t find those posts, maybe it wasn’t you. But yes, I need to charge my batteries using my generator, via the ac put on my inverter. I’m assuming some of my parameters in the inverter need changed, because I wired the ac input to the generator, but it didn’t start charging the batteries like...

I can’t find those posts, maybe it wasn’t you. But yes, I need to charge my batteries using my generator, via the ac input on my inverter. I’m assuming some of my parameters in the inverter need changed, because I wired the ac input to the generator, but it didn’t start charging the batteries...

Kenny, you had previously shared with me what your settings were (see photos). I want to charge my batteries with my generator. What settings do I need to change (and to what) in order to do this? Thanks!

Thanks guys. Sungold’s instruction manual leaves quite a bit to be desired…

33! That immediately got rid of the error! What does Pylontech refer to?

I did this, as I noted in a different post, but the error is still there.

I made all of these changes, and as I had an error before I even started, it is still there. I did put the communications cable into the “RS485 A”port, and all subsequent connections between batteries into the B and C, as was suggested, but that did not change anything, the error is still there

Disconnect the cable before I change the parameters? Or leave it unplugged?

I have 48v 100 Ah Lithium Iron Phosphate batteries with the sungold 10kw inverter. I have my battery type set to “user” because there in no preset for lithium. Would these values be good for me also? I’m not connected to the grid. Thanks.

Hello all, I just was following along on this thread after finding it on Google, because I’m having some similar issues. I have the 10,000 W hybrid inverter from Sungold, and 6 of their 100 amp power 48 V batteries. I am seeing error 58 (BMS Communication Fault in the manual) on my Inverter...