Recent content by BenCos18

from what I remember from earlier in this thread he has it mounted under his eaves bascilly iirc

looks good

I think you just need to get a controller that supports wind and wire it alongside your existing controller tbh You shouldn't need to change much else after from adding the two wires for positive and negative to the battery/busbar

Yep I forgot that part auctully Thanks

That is correct

Yep That's definitely worth a shot Also got my 3d printer up and running again recently so I might try and get some of the filament and give it a shot if I get round to it lol

Haha That explains it lol

Yep Just measured both of my lifepo4 packs I have and they all have the same voltage as yours

I actually gave no idea tbh I will defn do some research and try and find out though

the battery voltage will settle to around 13.3 to 13.2 once you take the charger off (about 3.3 volts or so per cell) So no you likely didn't get ripped off tbh

The model number defn seems to tell me they are 50Ah cells I'd be suprised if they are 200Ah cells tbh...generally the model number is pretty accurate I wonder whether they did a 16s 4p pack (4 cells in parell and then 16 in series)

It's a regular rg45 to rg45 network cable....Any should work just make sure it's a straight through and not a crossover though

looks amazing Nice job...puts my small 272Ah 200watt system to shame :LOL:

You won't see any load measurement on the charge controller if you don't use the controller load outputs (I think a current shunt and a separate battery monitor is the best way to measure the load anyway tbh....just size it to your amperge though)

It's most likely will tbh I know my power supply (very similar to OPs) had the exact same issue and was sorted that way