Hello all,
I have recently purchased a mppsolar 8048max , i connected the AC in and the unit turns on, however the battery is not detected.
The battery bank is 4x 12v chins lifepo batteries connected in series.
When i connect the batteries the unit does not detect them. When i measure the...
update: I soldered the connections and its working again. This model of the renogy rover has very little solder on the connections... I contacted Renogy and the warranty is 2 years, which after checking is the exact amount of time ive been using this .
Now I purchased an EPEVER to replace this one.
I bought a renogy rover 40A in nov 2017, today i noticed that the negative connected to the battery was very hot, and it melted a piece of the plastic. The connector marked in the picture is loose . Can i solder this connector back to the board and will it work properly again?
The battery cable...
Anyone know a DIY solution to monitor AC currents via the clamp sensor.
i found this Emporia Vue Smart Home Energy Monitor , but im looking for a cheaper solution.
I have a solar setup containing 24v system: 10x100 watt panels and 1x 40A renogy rover and 2x 200ah agm batteries in series. running since 2018
Ive noticed 4 days now that the controller would not go into float mode. It remains in boost mode. I removed all load, but still nothing . Tested it...
Hello there,
I have a solar setup containing 24v system: 10x100 watt panels and 1x 40A renogy rover and 2x 200ah agm batteries in series.
I want to expand my system with another 10+ 100watt panels.
Would anyone recommend adding another renogy rover 60A LI in parallel ? or add the EPEVER in...