-
-
bolhuijo reacted to 740GLE's post in the thread Danger of chopping MC4 extension cables in half with
Like.
For me it was using the wrong pin when crimping, the male pin goes in the female connector, needless to say I’ve snipped off 3-4 MC4... -
FYI I searched the name that was on the black plastic So... Don't google "Young man 6-way..." :'(
-
I found that there is an app/website that generates a global map of the greenhouse gas generated per kWh in semi-realtime. I have found...
-
bolhuijo replied to the thread Anyone running Onan RV generators for Off-Grid backup.Instructions unclear... I rewired my Predator generator with 40 poles but it won't run smoothly at 180RPM.
-
bolhuijo reacted to ampsarus's post in the thread Anyone running Onan RV generators for Off-Grid backup with Like.
Hoover Dam runs at 180 RPM to produce 60Hz The Onan is 10x that speed. My Honda is fuel injected and inverter output, but it can still...
-
bolhuijo replied to the thread MC4 connectors won't snap-connect.Last time I ran across this exact situation I loosened the clampy nut on the wire side of one of the MC4 connectors and it allowed the...
-
bolhuijo replied to the thread Seplos Mason BMS defective thermal sensor..I would guess that once the fault is cleared, the BMS will start working, no reset necessary (probably). Cell temp sensor wires are...
-
-
hmmmmm… maybe if it were blue… maybe…!
-
bolhuijo reacted to JWLV's post in the thread Danger of chopping MC4 extension cables in half with Like.
I always use a small piece of red heat shrink tubing on any cables that I cut. Heat shrink tubing lasts a lot longer than a piece of tape.
-
bolhuijo reacted to SparkyJJO's post in the thread Danger of chopping MC4 extension cables in half with
Haha.
Red cables with the word "black" in black sharpie, and black cables with "red" written in red sharpie. -
bolhuijo replied to the thread Why would Eaton do this?.That's a solid power strip, built for 24/7/365 use in a crowded hot data center cabinet, running 15.9 Amps constant just on the verge of...
-
16A max continuous on a 20A circuit.
-
Because the power strip is designed to be safe when connected to a standard 120V, 20A branch circuit. The twist lock connector is...
-
bolhuijo reacted to LeeStanphill's post in the thread Danger of chopping MC4 extension cables in half with Like.
I wouldn't mix colors on a customer rig, but on my personal stuff I've mix and matched to save money, but put a piece of color...
-
bolhuijo replied to the thread Danger of chopping MC4 extension cables in half.I have some orange cables that came with my battery. I think I will write "red" and "black" on them with a sharpie.
-
bolhuijo reacted to KITROBASKIN's post in the thread Danger of chopping MC4 extension cables in half with Like.
Easy enough to place red tape on the positive end of the black cable, black tape on the negative end of the red cable?
-
bolhuijo reacted to underdog5004's post in the thread Danger of chopping MC4 extension cables in half with Like.
Same thing happened to me. I ran an extension cable from the panel on top of my truck to the charge controller under the hood and I...
-
bolhuijo reacted to dougbert's post in the thread Danger of chopping MC4 extension cables in half with Like.
trust but verify
-
bolhuijo reacted to v_green57's post in the thread Danger of chopping MC4 extension cables in half with Like.
Which is why I ALWAYS apply the DVM to the connectors to cross check. Even on brand-new panels.
-
bolhuijo posted the thread Danger of chopping MC4 extension cables in half in Up in smoke... learn from my mistake!.As I was planning my panel layout, I knew I had 2 strings and needed about 100 feet of wire. I also knew I only needed MC4 connectors...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
