Most reacted posts

It shows updated.

If I use the low voltage disconnect do I still need to install inline fuse with each light?

My Bluetti shows a draw of 325 watts with nothing plugged in and all lights in my rv off. Fridge is on propane and so is water heater. Anyone have an idea why it’s showing an output?

When buying solar panels if I’m going to run them in parallel as a 12 volt system can I use 24 volt panels?

Can you replace MC4 connectors with regular butt splices or wire nuts? I can’t find a store that carries them and my address is not recognized by Amazon so ordering stuff online is always a pain.

Can I cut off the Anderson connectors and just install a more common connector or is there a reason Anderson connectors are more often used ?

Can someone explain how to connect my AC 200 Max to my RV DC system? How can I run my DC system without the rv charge converter? With the converter it use 325 watts with nothing else running and the Bluetti goes dead a few hours?

But how do I wire the Bluetti into the rv 12 volt system so the Bluetti is powering the rv dc system?

What I want to do is use the Bluetti in place of the rv batteries.

No, when I unplug the RV there’s no drain.

I have shut it down completely and rebooted, I’ve also ran it completely dead then charged to 100%. Yes it does show the battery percentage going down. My last test it was at 100% at 3am and with nothing plugged into the trailer and all lights off it was totally dead by 8am

If I am wanting to install 12 volt lighting for a small cabin, how do I wire it before the inverter? Do I just run two wires directly from the batteries to a buss bar or what?

I have the RV plugged directly into the RV receptacle on the Bluetti. Tv and router are unplugged from the power strip and all lights are off, nothing plugged into any receptacle at all.