BossHawk

When buying solar panels if I’m going to run them in parallel as a 12 volt system can I use 24 volt panels?

Can you replace MC4 connectors with regular butt splices or wire nuts? I can’t find a store that carries them and my address is not...

What I want to do is use the Bluetti in place of the rv batteries.

But how do I wire the Bluetti into the rv 12 volt system so the Bluetti is powering the rv dc system?

Can someone explain how to connect my AC 200 Max to my RV DC system? How can I run my DC system without the rv charge converter? With...

Yes, you can replace them with something else, just make sure they have the proper voltage and current ratings. Best to have the...

Anderson connectors are a reliable and commonly used connector for systems that need a 'disconnect', are readily available worldwide and...

Can I cut off the Anderson connectors and just install a more common connector or is there a reason Anderson connectors are more often...

No, when I unplug the RV there’s no drain.

I have the RV plugged directly into the RV receptacle on the Bluetti. Tv and router are unplugged from the power strip and all lights...

It shows updated.

I have shut it down completely and rebooted, I’ve also ran it completely dead then charged to 100%. Yes it does show the battery...

My Bluetti shows a draw of 325 watts with nothing plugged in and all lights in my rv off. Fridge is on propane and so is water heater...

If you use one of the 12v fuse blocks as a load centre (recommended, aren't they cute?) Then each circuit will already be fused.

If I use the low voltage disconnect do I still need to install inline fuse with each light?

Via a Low Voltage Disconnect. DC loads are notorious for taking batteries to thier death.

If I am wanting to install 12 volt lighting for a small cabin, how do I wire it before the inverter? Do I just run two wires directly...