Recent content by Chrizbr

Hello, I have this option in the Solarman app for my inverter, if I turn it off it lowers the loads on the inverter and the production remains higher, and if I turn it on they go up and are even with the production of the PV. I don't have batteries, and I don't export to the grid either.

I have a Megarevo inverter. I want to install an Orange Pi to use with Solar Assistant, I want to know what recommendations you give me to energize the Pu inside the inverter, or in the Wireway. We did the installation, but I forgot how to power it without having to use a power extension cord.

47.8 x 240 = 11,472 My manual says 41.7a

Yes, that's how I understand what it should be. But maybe I worded the question wrong, and her answer confused me. So if the connection is made in only load 1, the inverter must support and withstand 10kw?

That is also my understanding that the inverter is 10kw, and should provide 10kw in a single load output, but according to MR's response it makes me understand that both loads provide 5kw for a total of 10kw. So I want the installer to do the job right so there are no problems since the house is...

Yes, I think there is also a language barrier in which it is perhaps difficult to communicate. This would be the question I asked MR.

Exactly, then how should it be connected to use the full capacity of the inverter? Any diagram or instructions for 120/240?

Exactly, the megarevo staff told me the information found in the message. Meaning that if I want to be able to use 10kw, I have to use the two load outputs.

Could you tell me or draw a way that can be done? The house is from Puerto Rico.

The question comes because in order to use the 10KW of the inverter, you have to use the two Load outputs. Load 1 and Load 2. Then the electrician will take both loads to join them as in the drawing to have 120 on one side, and 120 on the other to give a total of 240 and thus energize both...

I have this inverter, loads 1 and 2 are being joined together to make just one. According to the manufacturer, load 1 is 5KW, and load 2 is the same. Load1 5KW + Load 2 5KW for = 10KW. You have to add both to give 10kw to the house. The red connection found in the red part of the wireway will be...

Ant update with zero export?

Hi, Any update?

Which brand is better, or which one would you choose?

Hello, I would like to know your opinion. I bought a Powmr 10k inverter. It is for indoor use, but I had thought to install it in the place of the black mark in the photo. The rain does not enter the garage, but perhaps the dust or a little dirt like anywhere else.