Drunkin Solar

Yes you can easily Connect the load terminals from the Victron to the XT60i input of the Delta2 via an on/off switch. Turn switch on...

One is a lithium polymer the other is lithium phosphate

I was hoping that you would say something like, "I make the meatballs".

2nd YEAHHHH... today I've just got the final approval from the local electrical energy provider :) :cool:(y) At 11am I've flipped the...

YEAHHHH... with one day delay, I've just got the final approval from the cities building division :) :cool: (y) Now there is only...

So that's 13A of 120V, so say 120*13=1560W Charger is running 35A at say 58A, needs 2030W. So yes you'll be limiting the charge rate...

As I mentioned in a previous thread, I'm looking into using the above stated components for a mobile workshop application. I think for...

Okay I wondered the correct procedure on this. I have three packs being assembled soon and can only initially charge them one at a time...

Would it be better to charge the packs together? You would wind up with separate packs sitting in a different state of charge when done...

It started here: https://diysolarforum.com/threads/new-system-layout-issues-qs.37210/ I have a few finishing touches still but I have...

Have been using the t-mobile home internet router since last fall. They had a deal if you switch service to them (2 phones) and got...

I used my phone for a hotspot for a long time with Verizon. They would throttle the speed for hotspot data after a certain amount of...

48/1200 running an oil filled heater:

More like 200 watts. I ignore the DC watts becasue in this case they are imaginary.

Here’s my ESS under a fairly hefty load at a moment in time this morning. Total consumption: 7910 W Total DC power in: 7273 W battery...

So what we see here is about a 150w consumption there Mr. Q-Dog?

SOC is calculated by the Multi and that data is passed to the Cerbo so you can see it in the VRM in most normal setups. But you can...

That was my thinking. If you give it time, which I have plenty of, at some point (hopefully) things are good enough to commission it...

Also set the SCC to float 8*3.45v and let it bake. If you’re not in a rush let the BMS do its job.

Just remember to hit the switch in the app to turn OFF the "balance while charging" so it will continue to balance all night when...