Have a new Growatt sc4880 mppt. Seems to be working fine. My panel is putting out 20-30v but zero amps (0.0). This was later this evening with zero sun and quite overcast and cloudy. I’m just curious if that is normal and it’s just so low that it wasn’t reading at all. Picture of panel tag...
Westinghouse
iGen4500DFc 4500-Watt/3700-Watt Dual Fuel Inverter Generator with Electric/Remote Start, RV-Ready Outlet, and CO Sensor
I do not have the fob on me at the moment. I'll have to get that and post it next monday.
I understand what it does, not sure how i'd wire it. I have a remote start gen and would really like to set this up if someone could explain in detail how to do it
Can anyone tell me which wires go to the busbar and which don't? Diagram maybe? I can't find a diagram that actually tells you which wire goes where on the busbar...
Curious... why do I need an 80-100amp fuse from the batteries to the scc, when the scc is only converting 20-25 amps from my panels? How am I supposed to run 2ga from an scc that only takes up to an 8ga... so confused
I have 2 405w panels 9.86a 41.1v pmax 10.37 49.1 isc/voc. So approx 42v 20a coming out. Going to connect them in parallel. Hoping someone can tell me how to wire them from the Y to the mppt... so many conflicting ideas people have... Do I put an inline fuse on each panel(15a) or just after the...
I have not yet, but I can say I am very disappointed in the Renogy 2000w inverter/charger I got. It lasted about a month and only used it maybe 4 times before it stopped charging or letting pass through shore power.