gcap

I was interpreting it as the BMS asking for that voltage, not setting it as a limit. Now I get it, because I thought the BMS was asking...

I tested my setup with a full charge and the updated settings to see how DVCC would do and all seems fine to me. I'm still not sure how...

Yes of course, I'm still new to this so don't remember all the settings. I remember setting it at 48V shutdown, 49V restart and 49.5V...

Ok, I understand the Batrium, I was sure the discharge floor % in the shunt told the multiplus to stop inverting , good to know. SO...

OK, thanks all, there's a lot of info to get into here. Is a Batrium an external bms or SmartER Shunt? With regard to the "time to go"...

Sorry about that, yes, I added the photos to clarify what I'm seeing. I still have my doubts about it functioning properly though. I...

Hi, when you say "BMS not tied to the Cerbo" what do you mean?

I’ve recently completed the first steps of my first system ( see signature ) and have been getting familiar with the settings in the...

Much Appreciated, The settings will remain.

Hi After updating settings MP went immediately to Bulk, Absorption and finally Float With your setting suggestions ( copied from...

HI sunshine_eggo , In your screenshot above your battery is at 57.76v, at what voltage does your bms charge cut-off engage? Also, I...

Thanks for your info, I'll answer what I can and will try to find the answers to the rest in another post if necessary. While the batts...

I have just installed the first components to my home backup system charging from the grid, solar will follow in the spring. Multiplus...