Im switching my 13yr old system over to LiFePO4 batterys. 2 Jita 12V 300ah in series to be exact. My charge controller is a Xantrex 150/60 MPPT and it has a setting for what voltage it will restart Bulk charge. My question is what should that voltage be? This is an off grid cabin which always...
Hello, My Magnum inverter MS4024 is reading around +3VDC higher then the battery's actual voltage. Its causing me a lot of problems because the low voltage cut off and on is way off from reality. This thing has been in service for 15years. Any ideas on how to fix this? Is there a calibration...
I have eg4 6000xp and powerPro battery off grid at a remote location and I check the PC monitor app all the time. It works fairly well but could be better. I have some comments suggestions for improvement. I suppose this would also apply to phone app and the 18K. So EG4 if your listening...
1...
About to mount my battery to a concrete wall, was looking to elevate it off the ground and remove the feet. But then see this in the install manual. So is this a wall mount battery or not? Is the mounting bracket and battery case not up to the task? It comes with 6 concrete anchors. I have a...
I commissioned my 6000xp and its connected to eg4 powerpro battery a month ago. EG4 monitor is set to "Lithium" battery and com set to "0:EG4" so im using SOC% and not setting absorb/float voltages. The online XP Monitor can read the battery stats. Where are the charge settings coming from...
For the past 15 years I've been running a small DC surface pump on a 70w panel at about 1gpm when the sun shines. But my spring dry's up early in the year these days so getting a 4 inch well drilled in a month or so. Will likely be <200ft deep. Im going to need a submersible pump and controller...